|
"SEW"
Hydraulic press brake are manufactured for fabrication operations
which demand accuracy, quality & productivity in their forming requirements.
In order to deliver performance, reliability & precision bending
under the toughest conditions, we are committed to quality & workmanship
throughout the entire manufacturing, assembling & testing processes.
|
|
-
Sturdy welded frame is designed for maximum resistance to deflection
- Torsion bar is designed for beam stability & parallelism
- Cylinder (Y1 & Y2) are manufactured from high quality steel
and designed to maximum seal interfaces, load concentration and
wear points
- High quality low friction pressure seals are used
- Front operated power adjustment depth setting. It is equipped
by mechanical depth stops by precision gear box transmission.
- Precision mechanical stops provide repeatability of the beam movement
to facilitate consistent bending results
- Manifold hydraulic block is designed with highly efficient valves
to provide, low noise and smooth reversal system
- Selectors switch for foot, hand, auto, inch operation controls
- Ram is of one piece construction and is guided with long adjustable
gibs, ground finished and fitted with non-metallic liners
- Bed is of welded construction with precisely hand scrapped table
top surface
- Piston rods are hard chromed and grounded for smooth and trouble
free performance
- Three speed bending operation includes last free fall, stable
bending and rapid return to facilitate good production cycle times
- Simple switch point control of ram front free fall to bending
speed is adjustable
- Adjustable tonnage control with readout from Zero to full tonnage
enables operator to set the required tonnage
- Holding time of Zero to five seconds allows better bending results
|
